A small metallic sphere of diameter 2 mm and density is dropped in glycerine having viscosity 10 Poise and density respectively. The terminal velocity attained by the sphere is __ .
- A
1.5
- B
2.0
- C
1.0
- D
3.0
Every Mechanical Properties of Fluids question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 193 questions across 9 distinct ideas. Free to read, answer key on every one.
Questions
193
Distinct ideas
9
Share of marks
4.2%
Difficulty
MEDIUM
A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Mechanical Properties of Fluids questions actually test.
1–20 OF 193 · NEWEST FIRST
A small metallic sphere of diameter 2 mm and density is dropped in glycerine having viscosity 10 Poise and density respectively. The terminal velocity attained by the sphere is __ .
1.5
2.0
1.0
3.0
A cubical block of density floats in a liquid of density . If the height of block is H = 8.0 cm then height of the submerged part is ________ cm.
6.3
4.3
7.3
5.3
When a part of a straight capillary tube is placed vertically in a liquid, the liquid raises up to certain height h. If the inner radius of the capillary tube, density of the liquid and surface tension of the liquid decrease by 1 % each, then the height of the liquid in the tube will change by __ %.
+3
-3
+1
-1
A water spray gun is attached to a hose of cross sectional area 30 cm. The gun comprises of 10 perforations each of cross sectional area of 15 mm. If the water flows in the hose with the speed of 50 cm/s, calculate the speed at which the water flows out from each perforation. (Neglect any edge effects)
m/s
m/s
m/s
m/s
Eight mercury drops, each of radius coalesce to form a bigger drop. The surface energy released in this process is_________ .
( S is the surface tension of mercury).
A liquid of density 600 kg/m flowing steadily in a tube of varying cross-section. The cross-section at a point is 1.0 cm and that at is 20 mm. Both the points and are in same horizontal plane, the speed of the liquid at is 10 cm/s. The difference in pressures at and points is __________ Pa.
18
144
36
72
A cylindrical vessel of 40 cm radius is completely filled with water and its capacity is 528 dm (dm : decimeter). The vessel is placed on a solid block of exactly same height as vessel. If a small hole is made at 70 cm below the top of water level, then horizontal range of water falling on the ground in the beginning is __________ cm.
A spherical liquid drop of radius acquires the terminal velocity when falls through a gas of viscosity . Now the drop is broken into 64 identical droplets and each droplet acquires terminal velocity falling through the same gas. The ratio of terminal velocities is __________.
4
0.25
32
16
The surface tension of a soap bubble is 0.03 N/m. The work done in increasing the diameter of bubble from 2 cm to 6 cm is J. The value of is : (Take )
Surface tension of two liquids (having same densities), and , are measured using capillary rise method utilizing two tubes with inner radii of and
where r_{1} > r_{2}. The measured liquid heights in these tubes are and respectively. [Ignore the weight of the liquid about the lowest point of miniscus]. The heights and and surfaces tensions and satisfy the relation :
and
h_{1} > h_{2} and T_{1} < T_{2}
h_{1} < h_{2} and
h_{1} > h_{2} and
An air bubble of volume 2.9 rises from the bottom of a swimming pool of 5 m deep. At the bottom of the pool water temperature is C. The volume of the bubble when it reaches the surface, where the water temperature is C, is ______.
(, density of water = , and 1 atm pressure is Pa)
3.0
2.0
4.5
4.2
Water flows through a horizontal tube as shown in the figure. The difference in height between the water colunms in vertical tubes is 5 cm and the area of cross-sections at A and B are and respectively. The rate of flow will be ____ .

If an air bubble of diameter 2 mm rises steadily through a liquid of density 2000 kg/m at a rate of 0.5 cm/s, then the coefficient of viscosity of liquid is _________ Poise. (Take m/s)
Given below are two statements:
Statement I : Pressure of a fluid is exerted only on a solid surface in contact as the fluid-pressure does not exist everywhere in a still fluid.
Statement II: Excess potential energy of the molecules on the surface of a liquid, when compared to interior, results in surface tension.
In the light of the above statements, choose the correct answer from the options given below
Both Statement I and Statement II are true
Statement I is true but Statement II is false
Both Statement I and Statement II are false
Statement I is false but Statement II is true
A liquid drop of diameter 2 mm breaks into 512 droplets. The change in surface energy is J. The value of is __________. (Take surface tension of liquid = 0.08 N/m)
The surface tension of a soap solution is N/m. The work required to increase the radius of a soap bubble from 1 cm to 2 cm is J. The value of is _____.
A soap bubble of surface tension 0.04 N/m is blown to a diameter of 7 cm. If (15000 - x) of work is done in blowing it further to make its diameterl4 cm, then the value of x is_____.
Sixty four rain drops of radius 1 mm each falling down w-ith a terminal velocity of 10 cm/s coalesce to fonn a bigger drop. The terminal velocity of bigger drop is_____cm/s
The terminal velocity of a metallic ball of radius 6 mm in a viscous fluid is 20 cm/s. The terminal velocity of another ball of same material and having radius 3 mm in the same fluid will be ________ cm/ s.
A tub is filled with water and a wooden cube 10 cm × 10 cm × 10 cm is placed in the water. The wooden cube is found to float on the water with a part of it submerged in water. When a metal coin is placed on the wooden cube, the submerged part is increased by 3.87 cm. The mass of the metal coin is __________ gram. (Take water density as 1 g/cm and density of wood = 0.4 g/cm)
OTHER PHYSICS CHAPTERS