A series LCR circuit consists of . , and . The input voltage is 2500 V. The amplitude of current, in the circuit, is ______ A.
Every Alternating Current question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 165 questions across 7 distinct ideas. Free to read, answer key on every one.
Questions
165
Distinct ideas
7
Share of marks
2%
Difficulty
EASY
A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Alternating Current questions actually test.
61–80 OF 165 · NEWEST FIRST
A series LCR circuit consists of . , and . The input voltage is 2500 V. The amplitude of current, in the circuit, is ______ A.
An LCR series circuit of capacitance 62.5 nF and resistance of 50 , is connected to an A.C. source of frequency 2.0 kHz. For maximum value of amplitude of current in circuit, the value of inductance is _____ mH. (Take )
An ideal transformer with purely resistive load operates at 12 kV on the primary side. It supplies electrical energy to a number of nearby houses at 120 V. The average rate of energy consumption in the houses served by the transformer is 60 kW. The value of resistive load required in the secondary circuit will be ______ m.
A series combination of resistor of resistance 100 , inductor of inductance 1 H and capacitor of capacitance 6.25 F is connected to an ac source. The quality factor of the circuit will be _____.
A series LCR circuit is connected to an ac source of 220 V, 50 Hz. The circuit contain a resistance and an inductor of inductive reactance . The capacitance of the capacitor needed to maximize the average rate at which energy is supplied will be _____ F.
In an ac generator, a rectangular coil of turns each having area m is rotated at rev min about an axis perpendicular to a uniform magnetic field of magnitude T. The maximum value of the emf produced will be ______ V. [Take ]
A series LCR circuit is connected to an AC source of 220 V, 50 Hz. The circuit contains a resistance , an inductor of inductive reactance , and a capacitor of capacitive reactance . The power factor of circuit is . The value of is:
Match List - I with List - II.
| List-I | List-II |
|---|---|
| (A) AC generator | (I) Detects the presence of current in the circuit |
| (B) Galvanometer | (II) Converts mechanical energy into electrical energy |
| (C) Transformer | (III) Works on the principle of resonance in AC circuit |
| (D) Metal detector | (IV) Changes an alternating voltage for smaller or greater value |
A - II, B - I, C - IV, D - III
A - II, B - I, C - III, D - IV
A - III, B - IV, C - II, D - I
A - III, B - I, C - II, D - IV
If wattless current flows in the AC circuit, then the circuit is :
Purely Resistive circuit
Purely Inductive circuit
LCR series circuit
RC series circuit only
A sinusoidal voltage volt is applied to a series LCR circuit in which mH, F and . The phase difference between the applied voltage and resultant current will be
An alternating emf is applied to a circuit containing an inductance of H. If an a.c. ammeter is connected in the circuit, its reading will be:
4.4 A
1.55 A
2.2 A
3.11 A
To increase the resonant frequency in series LCR circuit,
Source frequency should be increased
Another resistance should be added in series with the first resistance
Another capacitor should be added in series with the first capacitor
The source frequency should be decreased
In a series circuit and power factor of the circuit is . When capacitor with capacitance such that is put in series, the power factor becomes . The ratio is
A direct current of and an alternating current of peak value flow through resistance of and respectively. The ratio of heat produced in the two resistances in same interval of time will be:
A series LCR circuit has H, and and it is connected to ac voltage of amplitude 50 V. At frequency 60% lower than resonant frequency, the amplitude of current will be approximately
466 mA
312 mA
238 mA
196 mA
The equation of current in a purely inductive circuit is . If the inductance is 30 mH then the equation for the voltage across the inductor, will be
A transformer operating at primary voltage 8 kV and secondary voltage 160 V serves a load of 80 kW. Assuming the transformer to be ideal with purely resistive load and working on unity power factor, the loads in the primary and secondary circuit would be
800 and 1.06
10 and 500
800 and 0.32
1.06 and 500
The current flowing through an ac circuit is given by A. How long will the current take to reach the peak value starting from zero?
s
s
s
s
The RMS value of conduction current in a parallel plate capacitor is . The capacity of this capacitor, if it is connected to AC supply with an angular frequency of , will be
When you walk through a metal detector carrying a metal object in your pocket, it raises an alarm. This phenomenon works on
Electromagnetic induction
Resonance in ac circuits
Mutual induction in ac circuits
Interference of electromagnetic waves
OTHER PHYSICS CHAPTERS